The parametric equalizer shapes the frequency response, for example to compensate room modes or the acoustics of the listening position. It works per output channel, so each speaker can be treated individually.
Global Enable Switch
The Enabled switch takes the whole equalizer in and out of the signal path. Use it to hear the difference of your settings directly, without changing any band.
Channels and Bands
Each channel menu (Front Left, Front Right, ... LFE / Subwoofer) lists its filter bands. Every band offers:
Enabled: switches the band on or off.
Filter Type: the shape of the band. Each graphic shows the frequency response of a typical boost and cut around the band frequency f (logarithmic frequency axis, level in decibels); Peaking and the shelves reverse their effect with negative gain.
Peaking
A bell-shaped curve around the band frequency f — the classic tool for room modes and resonances.
Low Shelf
A fixed boost or cut of all frequencies below f, e.g. for a warm bass foundation.
High Shelf
A fixed boost or cut of all frequencies above f, e.g. for more brightness.
Notch
A deep, very narrow cut at f that removes a single offending frequency, e.g. a mains hum. It always cuts; the Gain control is not shown for it.
Frequency: the center frequency of the band in hertz; in the graphics above it is marked as f.
Gain: the boost or cut in decibels; in the graphics above, boost is drawn green and cut gray.
Q Factor: the bandwidth of the band.
The same peaking band drawn with a low and a high Q: the low Q (green) spreads the boost over a wide range, the high Q (gray) concentrates it narrowly around f.
Attenuation: the signal is attenuated, only as much as the protection requires. The attenuation is tonally neutral: the character of the music does not change, only the overall volume drops a little.
Compressor: a bus compressor catches the peaks dynamically. It keeps the perceived loudness nearly constant, at the price of slightly reduced dynamics.